![]() ![]() Now attach your feedline to the bottom of the barrel connector. Create a triangle with the PVC pipe and attach the three bottom elements to. PVC pipe cut to abot four feet in length. The three bottom elements can be spread by using 1/2 in. Now take the wire that was spliced into the jumper and attach it to the top of the Barrel connector. Using a small clamp, attach the three bottom elements to a barrel connector (PL 258). Take three foot jumper cable and cut all but about an inch or two to splice to the top element. Use one of the wires as the radiating element and three as the elements. With a little bit of luck, you should now be able to tune into the CB radio station! Bear in mind that as your antenna is homemade, the signal and there quality of transmission may be poor - so whilst building a CB antenna is fun, it may be better to buy an antenna to use in the long run.Ĭut 4 strands of 12 gauge wire to 102 in. The remainder of the wire (that is coming out of the loop) should hang down to ground level, in order for you to plug it into your CB radio. The best way to achieve this height is to tie a rope or non-metal wire structure to your antenna and haul it up a tree or up the side of a building. For your CB antenna to receive signals, it will need to be located at least 20 feet above ground level. Tie the ends together and you should have a large loop formation. Attach antenna insulators to the ends of the coaxial cable wire. Find the hole in the braided shield and guide the wire through this, until around half the wire has been passed through. Then, grab yourself a coaxial cable metal braided shield (items like these can be found at various hardware stores) and pull it down your coaxial cable wire so the two lengths are parallel. Using a sharp edge, strip the outer insulation material from the wire. First of all, you will need a coaxial cable of length 100 inches. Building a homemade CB antenna requires a little skill, a lot of patience and a few vital materials. It will allow you to tune in and listen to whatever is being broadcasted on the CB channel. If you're interested in radio and would like to get more involved in the radio transmission process, building your own CB antenna is a great idea. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |